Beyond INF-B Manual del operador descargar pdf (Pagina 55)

Input Type Selection

12.2 INPUT TYPE: ( RTD )

ENTER INPUT TYPE MENU:

Press ‘MENU’ 1) Display shows "INPUt" Input Menu.

Press ‘RESET/ENTER’ 2)

Display flashes "VOLt" (default) or previous stored input type.

Press ‘䊱/MAX’ 3) Scroll through the available following input type selection list. Display

flashes:

"VOLt" (DC Voltage)

"CURRNt" (DC Current)

"bRIdGE" (Bridge)

"POt" (Potentiometer)

"tC" (Thermocouple)

"Rtd" (RTD)

If the displayed input type is "Rtd", press ‘RESET/ENTER’ to skip to Step 6

("Rtd" stops flashing).

Rtd "Rtd" RTD SUBMENU:

Press ‘䊱/MAX’ 4) Scroll through the available selection to "Rtd" (flashing).

Press ‘RESET/ENTER’ 5) Display shows "StOREd" stored message momentarily and then "Rtd"

(not flashing).

Press ‘RESET/ENTER’ 6) Display flashes previous RTD type selection. ie. "2Pt 392" default

(see Table below for types). If the display matches your choice of RTD

type. Go to Step 8

Press ‘䊱/MAX’ 7) Scroll through the available RTD types to the selection of our choice.

Press ‘RESET/ENTER’ 8) Display shows "StOREd" stored message momentarily and then

advances to the "RdG.CNF" Reading Configuration Menu.

Display RTD types

2Pt 392

2 wire, 100 Ohms, NIST RTD, alpha=0.00392

3Pt 392 3 wire, 100 Ohms, NIST RTD, alpha=0.00392

4Pt 392 4 wire, 100 Ohms, NIST RTD, alpha=0.00392

2Pt 385 2 wire, 100 Ohms, NIST RTD, alpha=0.00385

3Pt 385 3 wire, 100 Ohms, NIST RTD, alpha=0.00385

4Pt 385 4 wire, 100 Ohms, NIST RTD, alpha=0.00385

3.L INR 3 wire, linear RTD

4.L INR 4 wire, linear RTD

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 131 132

Sin comentarios

Beyond INF-B Manual del operador Pagina 55